1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE

Cold Engine

  1. Ensure engine coolant is below 122Β°F (50Β°C). Disconnect vacuum hose No. 27. Attach vacuum gauge to vacuum hose at tubing manifold. Check for vacuum at idle speed. If vacuum is present, proceed to HOT ENGINE test.
  2. If there is no vacuum, disconnect other hose and check for vacuum. If vacuum is present, replace thermo valve C and retest. If there is no vacuum, check auxiliary intake vacuum hose for leaks or blockage.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.