1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE

Starter Switch Signal

Plug system checker harness between ECU and connector. Turn ignition switch to START position. Connect voltmeter positive probe to terminal B13 (Blue/Red wire) and negative probe to terminal A18 (Black/Red wire). Battery voltage should be present at connector. If battery voltage is not present, check for blown starter fuse or an open circuit in Blue/Red wire (Blue/White wire on CRX Si) between starter signal fuse and ECU.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.