Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Alternator Fr Terminal Signal
- Plug system checker harness between ECU and connector. Connect voltmeter positive probe to terminal B14 (White/Red wire) and negative probe to terminal A18 (Black/Red wire). Start engine. Turn headlights on and off.
- Voltage should drop and then raise zero to 5 volts as headlights are turned on and off. If voltage does not change, turn off engine. Check for continuity in White/Red wire (Blue wire on CRX Si) between alternator and ECU. If continuity is present, check for faulty alternator and/or voltage regulator.
- If there is no continuity, check for open circuit in harness. Test FR terminal diode. Diode is faulty if continuity or no continuity exists in both directions between F and FR terminals of voltage regulator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
