Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Idle Control Solenoid Valve
- Idle control solenoid valve is activated by commands from ECU. When solenoid valve opens, vacuum enters hose between air filter and solenoid valve. Idle speed increases for an period of time after starting engine and whenever electrical loads are turned on.NOTE: Vacuum will disappear when engine RPM is raised above 1500-1700 RPM.
- While solenoid valve is being activated, 9 volts or more should be available between Black (Black/Yellow on Prelude) terminal (A) and Light Green (Green/Black on Prelude) (B) of valve leads.
- On Prelude, disconnect wire harness from idle control solenoid valve. Disconnect vacuum hose No. 26 from air flow tube. Apply vacuum to hose. Vacuum should hold constant.
- Connect positive battery terminal to Black/Yellow terminal of control box and negative battery terminal to Green/Black terminal. Disconnect vacuum hose No. 28 from intake manifold. Apply vacuum to vacuum hose No. 26. Vacuum should not hold constant.
- On Civic CRX Si models, open control box lid and disconnect wiring harness from control box. Disconnect No. 10 vacuum hose from idle control solenoid valve. Connect vacuum gauge to hose and apply vacuum. Vacuum should hold constant.
- Connect battery positive terminal to control box connector Black terminal and negative terminal to Light Green terminal. Apply vacuum to hose. Vacuum should not hold constant. If vacuum holds constant, replace valve.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
