1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE

CYL Sensor

Unplug CYL sensor connector. Measure resistance between White and Red (Orange on Prelude) terminals at sensor. Resistance should be 650-850 ohms. Measure insulation resistance between White and Red (Orange on Prelude) terminals of sensor and crank angle sensor housing. Resistance should be 100,000 ohms or more.

Fig 1: Testing CYL & TDC Sensors
G42702
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.