Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Vacuum Switch D
- Disconnect vacuum hose to vacuum switch D and connect a hand vacuum pump to hose. Apply vacuum to switch. Check for voltage at Red wire (1500 HF Fed.).
- Voltage should be available when vacuum below 1.2 in. Hg (1500 HF FED.) is applied. If there is no voltage, replace vacuum switch D and retest.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
