1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE

Vacuum Switch A

  1. Disconnect vacuum hose to vacuum switch A and connect a hand vacuum pump to hose. Apply vacuum to switch. Check for voltage at Black/Red wire (1300/1500 HF) or Black/Orange wire (1500 except HF) of vacuum switch A (Blue/Black wire on hatchback/sedan man. trans. with 1500 except HF).
  2. Voltage should be available when vacuum below 2 in. Hg (1300/1500 HF) or below 1.2 in. Hg (1500 except HF) is applied. If there is no voltage, replace vacuum switch A and retest.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.