1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE

Hot Engine

  1. Warm engine to operating temperature. Raise engine to 3500 RPM and close throttle suddenly several times. Check for vacuum at air valve hose No. 26. If vacuum is present, system is okay.
  2. If there is no vacuum present, disconnect vacuum hoses No. 19 and 20 from control valve and check for vacuum. If vacuum is present at both hoses, replace vacuum control valve and retest. If there is no vacuum present at hose No. 19, replace thermovalve A and retest.
  3. If there is no vacuum present at hose No. 20, check vacuum line to intake manifold for leaks or blockage. Repair or clean as necessary and retest.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.