Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Cold Engine
- Ensure engine coolant temperature is below 122°F (50°C) on 1300 models and 104°F (40°C) on 1500 models. Pinch vacuum hose No. 26 at control box No. 1. Disconnect vacuum hose No. 26 from air valve.
- Start engine. Quickly raise engine speed to 3500 RPM and close throttle suddenly several times. Check for vacuum at hose No. 26. If there is no vacuum present, proceed to HOT ENGINE test. If there is vacuum present, replace thermovalve A and retest.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
