Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Speed Sensor
- Raise and support front of vehicle. Push voltmeter or test light positive probe into Yellow/Black wire (Yellow wire on Accord) terminal at control unit connector.
- Connect negative probe to ground. Start engine. Place vehicle gear selector in "2" position and accelerate slowly. Battery voltage should be as shown in SPEED SENSOR VOLTAGE CHECK table.SPEED SENSOR VOLTAGE CHECK
Speed Voltage Below 6 MPH Yes Above 12 MPH No - If voltmeter readings do not correspond to appropriate MPH ranges, install a new speed sensor and retest. If there was no voltage during speed sensor test, check for bad electrical connection, fuse or faulty speed sensor. Replace or repair as necessary and retest.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
