Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Honda Prelude Automatic TransFACTORY OEM SERVICE PROCEDURE
Crankcase Ventilation Systems: Maintenance
Perform the following maintenance every 60, 000 miles or 5 years.
- Disconnect breather hose from carburetor insulator. Clean orifice with a No. 57 (.043") drill bit. Compressed air may also be used to clear tube.
- Inspect condensation chamber in air cleaner. Remove from air cleaner and clean thoroughly. Be sure gasket is installed in original position and all hoses are tight when reinstalling condensation chamber.
Note fresh air and blow-by vapor direction.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.