1997 Geo Tracker LSi, RWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Back-Up Lamp Switch 17 (23)
Clutch Cable Adjustment Nuts "A" & "B" 13 (18)
Clutch Cable Grommet Bolts (1)
Clutch Housing Bolts 33 (45)
Clutch Pedal Position (CPP) Switch Lock Nut (2)
Clutch Pedal Shaft Nut & Bolt 18 (24)
Clutch Pedal Stop Lock Nut (2)
Clutch Release Lever Nut & Bolt 17 (23)
Flywheel Bolts 48 (65)
Front Skid Plate Bolts 40 (54)
Pressure Plate 17 (23)
Transmission Rear Mounting Bolts 44 (60)
Transmission-To-Engine Nuts & Bolts 72 (98)
(1) Tighten bolts to 70 INCH lbs. (8 N.m).
(2) Tighten lock nut to 115 INCH lbs. (13 N.m).
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.