1997 Geo Tracker LSi, RWDFACTORY OEM SERVICE PROCEDURE

Fluid Capacities

FLUID CAPACITIES

Item  Condition  Specification (1)
Engine Oil Drained; With New Filter 4.5 Qts. (4.2L)
Engine Oil Drained: Front Differential 1.1 Qts. (1.0L)
Engine Coolant A/T: System Drained 5.5 Qts. (5.2L)
Engine Coolant M/T: System Drained 5.6 Qts. (5.3L)
Automatic Transmission Pan Removed: 3 Speed 3.0 Qts. (2.8L)
Automatic Transmission Pan Removed: 4 Speed 2.6 Qts. (2.5L)
Automatic Transmission After Complete Overhaul: 3 Spd 5.3 Qts. (5.1L)
Automatic Transmission After Complete Overhaul: 4 Spd 7.3 Qts. (6.9L)
Manual Transmission Four-Wheel Drive 1.6 Qts. (1.5L)
Manual Transmission Two-Wheel Drive 2.0 Qts. (1.9L)
Manual Transmission Rear Differential 2.3 Qts. (2.2L)
Manual Transmission Transfer Case 1.8 Qts. (1.7L)
Fuel Tank Two-Door Convertable 11.1 Gal. (42L)
Fuel Tank Four-Door Hard Top 14.5 Gal. (55L)
(1) Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.