Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Tracker LSi, RWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Distributor Flange Bolt | 15 (20) |
| Engine Coolant Temperature (ECT) Sensor | 11 (15) |
| Fuel Delivery Pipe Plug Bolt | 22 (30) |
| Fuel Pulsation Damper | 22 (30) |
| Fuel Rail Mounting Bolts | 17 (23) |
| Heated Oxygen Sensor (HO2S) | 32 (43) |
| Intake Air Temperature (IAT) Sensor | 11 (15) |
| Spark Plugs | 18-22 (24-30) |
| Throttle Body Mounting Bolts & Nuts | 17 (23) |
| INCH Lbs. (N.m) | |
| Fuel Pressure Regulator Bolts | 90 (10) |
| Idle Air Control (IAC) Valve Screw | 41-43 (4.6-4.9) |
| Throttle Position (TP) Sensor | 30 (3.4) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.