Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1997 Geo Tracker LSi, RWDFACTORY OEM SERVICE PROCEDURE

Ignition Timing

IGNITION TIMING ⁽¹⁾

Engine Application

Manual Transmission

Automatic Transmission

Tracker

⁽²⁾ 4-6 @ 800

⁽¹⁾	See Fig 1 for timing mark location.

⁽²⁾	With jumper wire installed between terminals No. 4 (Black wire) and No. 5 (Blue/Red wire) of test connector located between right strut tower and battery.

NOTE: Ensure ignition timing advances as engine speed increases.

Chapter Navigation

Return to Chapter: Ignition System

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.