1997 Geo Tracker LSi, RWDFACTORY OEM SERVICE PROCEDURE

Idle Speed

IDLE SPEED SPECIFICATIONS (1)(2)

Application Idle RPM
A/C Off 750-850
A/C On (3) 950-1050
(1) Transaxle or transmission in Neutral or Park.
(2) Idle speed is checked with scan tool and a jumper wire connected between duty check data link connector terminal No. 2 (Blue/Yellow wire) diagnostic request, and terminal No. 4 (Black wire) ground.
(3) Idle speed should be 750-850 RPM in any gear.
IAC DUTY AT SPECIFIED IDLE SPEED (1)

Application (2) Percent
Tracker 50
(1) See IDLE SPEED SPECIFICATIONSΒ  table.
(2) With A/C turned off (if equipped).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.