1997 Geo Prizm Base, StandardFACTORY OEM SERVICE PROCEDURE

Functional Test

  1. Turn ignition switch to ON position. Press washer switch and release. Windshield washer pump should squirt washer fluid on windshield. On models with intermittent wiper system, wipers should make 2 sweeps and return to park position.
  2. On models without intermittent wiper system, move wiper/washer switch to MIST position and release. Wipers should complete one full sweep and return to park position.
  3. On all models, move wiper/washer switch to LO position. Wipers should operate at low speed.
  4. On all models, move wiper/washer switch to HI position. Wipers should operate at high speed.
  5. On models with intermittent wiper system, move wiper/washer switch to INT position. Adjust delay time up and down. Wipers should operate in intermittent mode with delay times changing with adjustment.
  6. On all models, move wiper/washer switch to OFF position. Wiper should complete cycle and return to park position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.