Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Controls - Tests W/Codes 1.6 & 1.8L
- Introduction
- Self-Diagnostic System
- Summary
- Circuit Tests
- Diagnostic Tests
- DTC P0105 - Manifold Absolute Pressure (Map) Sensor Circuit
- DTC P0106 - Manifold Absolute Pressure (Map) System Performance
- DTC P0110 - Intake Air Temperature (IAT) Sensor Circuit
- DTC P0115 - Engine Coolant Temperature (ECT) Sensor Circuit
- DTC P0116 - Engine Coolant Temperature (ECT) Sensor Circuit Performance
- DTC P0120 - Throttle Position (TP) Sensor Circuit
- DTC P0121 - Throttle Position (TP) Sensor Circuit Performance
- DTC P0125 - ECT Excessive Time To Closed Loop Fuel Control
- DTC P0130 - Oxygen Sensor-1 (O2S-1) Circuit
- DTC P0133 - Oxygen Sensor-1 (O2S-1) Slow Response
- DTC P0136 - Heated Oxygen Sensor-2 (Ho2S-2) Circuit
- DTC P0141 - Heated Oxygen Sensor-2 (Ho2S-2) Heater Circuit
- DTC P0171 - Fuel Trim System Lean
- DTC P0172 - Fuel Trim System Rich
- DTC P0300 - Engine Misfire Detected
- DTCS P0301, P0302, P0303, & P0304: Cylinders No. 1-4 Misfire Detected
- DTC P0325 - Knock Sensor (KS) Circuit (1.8L VIN 8 Only)
- DTC P0335 - Crankshaft Position (CKP) Sensor Circuit
- DTC P0336 - Crankshaft Position (CKP) Sensor Circuit
- DTC P0340 - Camshaft Position (CMP) Sensor Circuit
- DTC P0401 - Exhaust Gas RECIRCULATION (EGR) Flow Insufficient
- DTC P0402 - Exhaust Gas RECIRCULATION (EGR) Flow Excessive
- DTC P0420 - Three-Way Catalyst (TWC) System Efficiency Low
- DTC P0500 - Vehicle Speed Sensor (VSS) Circuit
- DTC P0505 - Idle Control System
- DTC P1300 - Ignition Control Module (IGNITOR) Circuit
- DTC P1335 - Crankshaft Position (CKP) Sensor Circuit
- DTC P1520 - Stoplight Switch Circuit (A/T)
- DTC P1600 - Pcm Battery
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
