1997 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS

Component Component Location
A/C Amplifier Behind right side of dash, above evaporator case.
Blower Motor Resistor Behind glove box.
Cruise Control Diode Behind left side of dash, taped to harness.
Data Link Connector (DLC) On left strut tower. See Figure .
Data Link Connector - On-Board Diagnostics II (DLC-OBD II) Behind left side of dash, attached to knee bolster. See Figure .
Distributor Left side of engine. See Figure .
Fuel Pump Noise Suppressor In fuel tank, on fuel sender assembly.
Ignition Coil Mounted to distributor, beneath distributor cap & rotor.
Noise Suppressor Condenser Mounted inside distributor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.