1997 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS

Component Component Location
G100 At left front inner fender.
G101 At left side of engine compartment, on top of transaxle.
G102 At left front inner fender, behind left headlight.
G103 At right side of engine, on intake manifold.
G104 At right front inner fender, behind right headlight.
G105 At left side of engine compartment, on left strut tower.
G106 At right side of engine, under intake manifold.
G200 Behind left kick panel.
G201 Behind center of dash, on left dash support brace.
G202 Behind center of dash, on right dash support brace.
G204 Behind right kick panel.
G300 At left "C" pillar.
G301 At left "C" pillar.
G400 At rear center of trunk, below deck lid striker.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.