1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE

Driver-Side Air Bag Inflator Module: Installation

  1. Inspect air bag inflator module for cracked deployment cover, damaged harness or evidence of physical damage (module dropped etc.).
  2. Fit inflator module on steering wheel and install mounting bolts. Ensure inflator module is aligned. Route inflator module harness neatly on back of module. See Fig 1. Tighten air bag inflator module bolts to specification. See TORQUE SPECIFICATIONSΒ . Connect 2 horn wire connectors. Reconnect negative battery cable. Enable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEMΒ .
Fig 1: Routing Wires On Rear Of Air Bag Inflator Module
G96J19397Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.