1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE

Mechanical Inspection: Compression

  1. Check engine mechanical condition using a compression gauge, vacuum gauge or engine analyzer. See engine analyzer manual for specific instructions. See COMPRESSION SPECIFICATIONSΒ  table.
  2. Clean any debris from around spark plug holes before removing spark plugs. Ensure battery is fully charged. Turn ignition switch to LOCK position. Remove all spark plugs. Disconnect distributor electrical connector and remove FI fuse from fuse box.
  3. Install compression gauge. Disengage clutch on manual transaxle equipped vehicles to reduce drag on engine. Fully depress accelerator pedal to Wide-Open Throttle (WOT) position. Using a fully charged battery, crank engine to at least 250 RPM. See COMPRESSION SPECIFICATIONS table. On each cylinder, record highest of 4 compression gauge readings and compare with table. If compression is not as specified, perform repairs as necessary.
COMPRESSION SPECIFICATIONS

Application Specification
Compression Ratio 9.5:1
Normal Compression Pressure (1) 199 psi (14.0 kg/cm2 )
Minimum Compression Pressure (1) 156 psi (11.0 kg/cm2 )
Maximum Variation
Between Cylinders 14 psi (1.0 kg/cm2 )
(1) Checked at 250 RPM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.