Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel System Pressure Release
Loosen fuel filler cap to release fuel tank pressure. Remove cover from relay/fuse box, located in left front corner of engine compartment, behind battery. See Fig 1. Remove fuel pump relay from relay/fuse box. Start and run engine until it stalls. Crank engine for about 3 more seconds to ensure residual fuel line pressure is released. Turn ignition off. Disconnect negative battery cable. Install fuel pump relay, cover, and tighten fuel filler cap.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.