Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE
Distributor Sensors
PICK-UP COIL AIR GAP (1)
| Application | Clearance In. (mm) | ||
|---|---|---|---|
| Metro & Firefly (Canadian) | .008-.016 (.20-.41) | ||
|
|||
PICK-UP COIL RESISTANCE (1)
| Application | Ohms | |||||||
|---|---|---|---|---|---|---|---|---|
| Measured Between Terminals No. 1 & 2 | ||||||||
| Cold (2) | 185-275 | |||||||
| Hot (3) | 240-325 | |||||||
|
||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.