Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES
| Component | Component Location |
|---|---|
| Back-Up Lamp Switch | On top of transaxle. |
| Brake Fluid Level Switch | In brake fluid reservoir. |
| Clutch Pedal Position (CPP) Switch (M/T) | Mounted above clutch pedal. |
| Dual Pressure Switch | On right of engine compartment, near strut tower. |
| Idle Switch (1.0L VIN 6) | Part of idle speed control motor. See Figure. |
| Idle Switch (1.3L VIN 9) | Part of idle speed control motor. See Figure. |
| Oil Pressure Switch | Front of engine, behind exhaust manifold. |
| Parking Brake Switch | Under floor console, on parking brake lever base. |
| Power Steering Pressure (PSP) Switch | Lower right front of engine compartment. See Figure. |
| Seat Belt Switch | In driver's seat belt buckle. |
| Stop Lamp Switch | On top of brake pedal bracket. |
| Transaxle Range Switch | Top of transaxle. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.