Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS
| Component | Component Location |
|---|---|
| G100 | At top of left side of transaxle. |
| G101 | At left front of engine compartment. |
| G102 | At left front inner fender. |
| G103 | At right front inner fender. |
| G104 | At right side of engine, on intake manifold. |
| G105 | At right side of engine, on intake manifold. |
| G201 | Behind left kick panel. |
| G202 | At center of dash, behind radio. |
| G203 | Under left side of dash, on junction block case. |
| G204 | Behind right kick panel. |
| G300 | Behind right rear quarterpanel. |
| G400 | At rear center of trunk. |
| G401 | At left side of liftgate door. |
| G402 | At left side of liftgate. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.