1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

CONNECTORS

Component Component Location
C108 (2 Pin) At left rear of transaxle.
C111 (2 Pin) At right rear of engine compartment.
C112 (Black, 16 Pin) At right rear of engine compartment.
C113 (Black, 16 Pin) At right rear of engine compartment.
C114 (2 Pin) At left rear of engine compartment, near strut tower.
C115 (2 Pin) At right rear of engine compartment, near strut tower.
C200 (Black , 12 Pin) Behind left side of dash, near junction block.
C201 (Natural, 12 Pin) Behind left side of dash, near junction block.
C203 (13 Pin) Behind left side of dash, near junction block.
C204 (2 Pin) Behind left side of dash.
C205 (Blue, 12 Pin) Behind right side of dash.
C207 (2 Pin) At right upper side of dash.
C208 (8 Pin) Behind left side of dash, near fuse block.
C210 (6 Pin) Behind center of dash.
C211 (6 Pin) Behind center of dash.
C212 (6 Pin) Behind left kick panel.
C213 (6 Pin) Behind right kick panel.
C214 (2 Pin) Behind right kick panel.
C215 (2 Pin) Behind right kick panel.
C300 (1 Pin) Under rear passenger seat.
C301 (1 Pin) Under rear passenger seat.
C304 (2 Pin) Under right side of rear passenger seat.
C305 (2 Pin) Under left side of rear passenger seat.
C306 (2 Pin) Attached to left "B" pillar.
C307 (2 Pin) Attached to right "B" pillar.
C308 (2 Pin) Attached to left "B" pillar.
C309 (2 Pin) Attached to right "B" pillar.
C400 (Natural, 10 Pin) At left front side of trunk.
C401 (Black, 6 Pin) At right "D" pillar.
C402 (6 Pin) At right rear corner of vehicle.
C406 (1 Pin) (2-Door) At center of hatchback door.
C406 (1 Pin) (4-Door) Near left rear speaker.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.