1997 Geo Metro BaseFACTORY OEM SERVICE PROCEDURE

Rectifier Test

  1. With rectifier assembly on bench, contact diode plate using one ohmmeter probe and each diode lead using other probe. Note ohmmeter reading. Reverse probes, and repeat test for all diodes.
  2. All diodes should show a low reading in one direction and no reading in opposite direction. If any rectifier diode is defective, replace rectifier assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.