1996 Geo Tracker Base, 4D Utility, RWDFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES

Component Component Location
A/C Fuse Holder Right side of engine compartment, attached to A/C compressor clutch relay.
A/C Fusible Link Connected to positive (+) battery terminal.
A/C Switch Fuse Behind center of dash.
Air Bag Fuse Box (1996) Under left side of dash, near fuse block No. 2.
Fuse Block (1.6L VIN U) Behind dash, left of steering column. See Figure .
Fuse Block (1.6L VIN 6) (1995) Behind dash, left of steering column. See Figure .
Fuse Block No. 1 (1.6L VIN 6) (1996) On right side of engine compartment, front of battery. See Figure .
Fuse Block No. 2 (1996) Under left side of dash.
Fusible Link Box On right side of engine compartment, in front of battery.
Power Window Circuit Breaker (1996) Mounted to fuse block No. 2.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.