1996 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Backup Light Switch 15 (20)
Bleeder Screw (1)
Center Crossmember-To-Radiator Support Bolts 45 (61)
Center & Rear Mount Bolts 45 (61)
Clutch Line Tube 11 (15)
Flywheel Bolts 65 (88)
Front Mount
Bracket Bolts 45 (61)
Mounting Bolts 47 (64)
Through-Bolts 64 (87)
Lower Control Arm Bracket-To-Body Bolts 94 (127)
Lower Mount Bolts 45 (61)
Main Crossmember-To-Body Bolts 152 (206)
Mount Cover Bolts 45 (61)
Pedal Assembly Bracket-To-Instrument Panel Bolt 11 (15)
Pressure Plate Bolts 14 (19)
Slave Cylinder Mounting Bolts (2)
Starter Bolts 29 (39)
Transaxle-To-Engine Bolts 34 (46)
Upper Transaxle Mount Bolts 45 (61)
(1) Tighten to 97 INCH lbs. (11 N.m).
(2) Tighten to 106 INCH lbs. (12 N.m).
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.