1996 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

Diagnosis of computerized engine control system should be performed in the following order:

1) Ensure all engine systems not related to computer are operating properly. DO NOT proceed with testing unless all other problems have been repaired. Perform ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECKΒ  before using CIRCUIT TESTS.

2) Check for any Technical Service Bulletins (TSBs) that may apply. Retrieve any DTCs that may be present. If DTCs were displayed, follow procedures in appropriate CIRCUIT TEST.

3) If DTCs were not displayed, and a driveability problem or intermittent problem exists, go to TESTS W/O CODES article.

NOTE: ALWAYS clear DTCs, confirm closed loop operation, and test drive vehicle after repairs are made. Ensure MIL does NOT illuminate.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.