Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clearing DTCS
To clear DTCs using scan tool, select CLEAR DTCs or CLEAR INFORMATION function. Follow scan tool manufacturer's instructions.
If a scan tool is not available, DTCs can be cleared by disconnecting one of the following power sources for at least 30 seconds:
- Power source to PCM (such as battery pigtail, relay, fuse, etc).
- Negative battery cable (loss of radio presets and/or clock settings will result).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.