1996 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Description

Prizm is equipped with ABS-VI anti-lock brake system. ABS-VI system uses electric motors to modulate displacement pistons. Anti-Lock Brake System (ABS) operates on each front wheel and both rear wheels. ABS-VI system consists of Electronic Brake Control Module (EBCM), system enable relay, 4 wheel speed sensors, hydraulic unit, 3 warning lights and brake switch.

EBCM uses signals from wheel speed sensor to determine when a wheel is about to lock up and adjusts hydraulic pressure to maintain optimum braking. ABS-VI cannot increase brake pressure greater than master cylinder pressure generated by driver. ABS-VI cannot apply brakes by itself.

NOTE: For more information on brake system, see BRAKE SYSTEM article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.