Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Geo Metro Base, 2D Hatchback, 1.3 9FACTORY OEM SERVICE PROCEDURE
Engine Performance DTCS
ENGINE PERFORMANCE DTCS
| DTC | Description |
|---|---|
| P0106 | MANIFOLD ABSOLUTE PRESSURE SENSOR PERFORMANCE |
| P0107 | MANIFOLD ABSOLUTE PRESSURE SENSOR CKT VOLTAGE LOW |
| P0108 | MAP SENSOR CIRCUIT VOLTAGE HIGH |
| P0112 | INTAKE AIR TEMPERATURE SENSOR CIRCUIT VOLTAGE LOW |
| P0113 | INTAKE AIR TEMPERATURE SENSOR CKT VOLTAGE HIGH |
| P0117 | ENGINE COOLANT TEMP SENSOR CIRCUIT VOLTAGE LOW |
| P0118 | ENGINE COOLANT TEMP SENSOR CIRCUIT VOLTAGE HIGH |
| P0121 | THROTTLE POSITION SENSOR SYSTEM PERFORMANCE |
| P0122 | THROTTLE POSITION SENSOR CIRCUIT VOLTAGE LOW |
| P0123 | THROTTLE POSITION SENSOR CIRCUIT VOLTAGE HIGH |
| P0125 | EXCESSIVE TIME TO ENTER CLOSED LOOP |
| P0131 | HO2S1 CIRCUIT VOLTAGE LOW |
| P0132 | HO2S1 CIRCUIT VOLTAGE HIGH |
| P0133 | HEATED OXYGEN SENSOR 1 (HO2S1) SLOW RESPONSE |
| P0134 | HO2S1 CIRCUIT ACTIVITY INSUFFICIENT |
| P0135 | HO2S1 HEATER CIRCUIT |
| P0136 | HO2S2 CIRCUIT |
| P0141 | HEATED OXYGEN SENSOR 2 (HO2S2) HEATER CIRCUIT |
| P0171 | FUEL TRIM SYSTEM LEAN |
| P0172 | FUEL TRIM SYSTEM RICH |
| P0300 | ENGINE MISFIRE DETECTED |
| P0301 | CYLS NO. 1-4 MISFIRE DETECTED |
| P0302 | CYLS NO. 1-4 MISFIRE DETECTED |
| P0303 | CYLS NO. 1-4 MISFIRE DETECTED |
| P0304 | CYLS NO. 1-4 MISFIRE DETECTED |
| P0335 | CRANKSHAFT POSITION SENSOR CIRCUIT |
| P0340 | CAMSHAFT POSITION SENSOR CIRCUIT |
| P0400 | EGR SYSTEM |
| P0420 | THREE-WAY CATALYST SYSTEM EFFICIENCY LOW |
| P0440 | EVAPORATIVE EMISSION SYSTEM |
| P0443 | EVAPORATIVE EMISSION SYSTEM PURGE FLOW INCORRECT |
| P0450 | EVAPORATIVE EMISSION SYS PRESSURE SENSOR CIRCUIT |
| P0455 | EVAPORATIVE EMISSION SYSTEM LEAK DETECTED |
| P0461 | FUEL LEVEL SENSOR CIRCUIT PERFORMANCE |
| P0463 | FUEL LEVEL SENSOR CIRCUIT VOLTAGE HIGH |
| P0500 | VEHICLE SPEED SENSOR (VSS) CIRCUIT (A/T ONLY) |
| P0500 | VEHICLE SPEED SENSOR (VSS) CIRCUIT (M/T ONLY) |
| P0505 | IDLE CONTROL SYSTEM |
| P0510 | CLOSED THROTTLE POSITION (CTP) SWITCH CIRCUIT |
| P0601 | POWERTRAIN CONTROL MODULE (PCM) MEMORY |
| P0603 | POWERTRAIN CONTROL MODULE (PCM) MEMORY RESET |
| P1250 | EARLY FUEL EVAPORATION (EFE) CIRCUIT |
| P1410 | FUEL TANK PRESSURE SYSTEM |
| P1450 | BAROMETRIC PRESSURE SENSOR CIRCUIT |
| P1451 | BAROMETRIC PRESSURE SENSOR PERFORMANCE |
| P1460 | COOLING FAN CONTROL CIRCUIT |
| P1500 | STARTER SIGNAL CIRCUIT |
| P1510 | BACK-UP POWER SUPPLY |
| P1530 | IGNITION TIMING ADJUSTMENT SWITCH CIRCUIT |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
