Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Geo Tracker Base, 1.6 U, AutomaticFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System DTCS
ANTI-LOCK BRAKE SYSTEM DTCS
| OEM Code | Description | ||||
|---|---|---|---|---|---|
| 2 | Open Isolation Solenoid Circuit | ||||
| 3 | Open Dump Solenoid Circuit | ||||
| 4 | Limit Valve Reset Switch Closed | ||||
| 5 | Excessive Dump Valve Action | ||||
| 6 | (1) Wheel Speed Sensor Signal Changed Rapidly | ||||
| 7 | Shorted Isolation Solenoid Circuit | ||||
| 8 | Shorted Dump Solenoid Circuit | ||||
| 9 | Open Rear Wheel Speed Sensor Circuit | ||||
| 10 | (2) Stoplight Switch On Constantly | ||||
| 11 | Shorted Rear Wheel Speed Sensor | ||||
| 13 | RWAL EBCM Malfunction | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
