Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Geo Tracker LSi, 1.6 6, AutomaticFACTORY OEM SERVICE PROCEDURE
Scan Tester Data
NOTE:
Information contained in the following table is typical of readings taken on vehicle with engine idling, upper radiator hose hot, throttle closed, transmission in Park or Neutral, closed loop status achieved and all accessories off (except as noted in tables). Not all devices and systems are used on all models. For additional information, see tester owner's manual.
TYPICAL DATA VALUES
| Tester Position | Units Measured | Nominal Value | ||||
|---|---|---|---|---|---|---|
| A/C Request (1) | Yes/No | No | ||||
| A/C Switch (2) | On/Off | Off | ||||
| BARO (1) | Volts/kPa | 4.00 (98) | ||||
| Charging EFF1 (2) | % | 10 | ||||
| Desired Idle | RPM | ECM Controls (Varies) | ||||
| EGR Gas Temp. | °F (°C) | 140-145 (60-65) | ||||
| EGR Solenoid | On/Off | Off | ||||
| Eng. Coolant Temp. | °F (°C) | 176-194 (80-90) | ||||
| Engine Speed | RPM | 750-850 | ||||
| Fuel EVAP Purge (2) | % | 0 | ||||
| Fuel EVAP VSV (1) | On/Off | Off | ||||
| Fuel Pump (2) | On/Off | On | ||||
| HO2S | Millivolts | 10-900 | ||||
| Idle Switch | On/Off | On | ||||
| Injector Pulse Width | Mil/Sec | 1.1-1.6 | ||||
| Intake Air Temp. (1) | °F (°C) | 149-167 (65-75) | ||||
| ISC Adjust Monit | % | 0 | ||||
| ISC Air Flow | L/Min | 25-40 | ||||
| L.T. Fuel Trim | Counts | 118 | ||||
| MAP (1) | Volts/kPa | 1.56 (39) | ||||
| Mass Air Flow (2) | g/S | 3.1 | ||||
| MPH | MPH | 0 | ||||
| O2 Activation (2) | Act/Deact | Activate | ||||
| Park/Neutral Pos | P/N/RDL | P/N (A/T) | ||||
| Park/Neutral Pos | P/N/RDL | RDL (M/T) | ||||
| Power Steering Sw | On/Off | Off | ||||
| Rich/Lean Stat | Rich/Lean | Switches | ||||
| Spark Advance | ° | 5-15 | ||||
| S.T. Fuel Trim | Counts | 127 | ||||
| System Voltage | Volts | 14.0-14.5 | ||||
| Throt Open Sol (1) | On/Off | Off | ||||
| Throttle Angle | ° | 0 | ||||
| Throttle Position | Volts | .85-.95 | ||||
| Time From Start (1) | Sec | Counts 0-510 | ||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.