Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Geo Tracker LSi, 1.6 6, AutomaticFACTORY OEM SERVICE PROCEDURE
Power Steering Pressure Switch
Power steering pressure switch is located on power steering pump. To test power steering pressure switch circuit, see Diagnostic Chart C-1 under DIAGNOSTIC CHARTS in this article.
NOTE:
If power steering pressure switch fails to close, or open circuit in wiring exists between ECM and pressure switch, engine may stall when wheels are turned. If power steering pressure switch fails to open or short to ground exists in wiring between ECM and pressure switch, idle quality will be affected.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.