1994 Geo Prizm Base, StandardFACTORY OEM SERVICE PROCEDURE

Code 21 (PRIZM) - Oxygen Sensor, Open Or Shorted Circuit: Notes

Oxygen (O2) sensor produces a varying voltage as engine reaches normal operating temperature. Voltage will vary from .1 (lean) to 1.0 (rich) volt. ECM monitors voltage and determines concentration of gases in exhaust and adjusts fuel to maintain air/fuel ratio. Code 21 will set if sensor input voltage at ECM is .35-.70 volt for 60 seconds or more with engine speed greater than 1500 RPM, and coolant temperature is greater than 176Β°F (80Β°C).

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Checks for faulty sensor.
  2. Checks for open in Black wire between ECM and sensor.
  3. Checks for open in Brown wire between ECM and G106.
  4. Checks for short to ground in Black wire between ECM and sensor, open in Brown wire to sensor (federal emissions only), and a faulty ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.