Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 42 (PRIZM) - Vehicle Speed Sensor Circuit, Open Or Shorted Circuit: Notes
Vehicle Speed Sensor (VSS) is an electronic relay mounted on transaxle. As transaxle rotates VSS, VSS provides speedometer with a vehicle speed input (voltage pulses). This signal drives speedometer. Speedometer converts vehicle speed input into a more precise waveform and provides ECM, and cruise control module with a vehicle speed input. ECM converts this input (ground pulses) into vehicle speed. Code 42 will set if vehicle speed input is not sensed at ECM with engine speed 3000-5000 RPM and transaxle in gear, for at least 8 seconds.
- Determines if VSS is functioning properly.
- Checks for open in power feed to VSS.
- Checks for open or short in ECM speed input circuit or a faulty ECM.
- Determines if ECM or speedometer is faulty.
- Checks for open in ground to VSS.
- Checks for open in power feed to speedometer.
- Determines if VSS or speedometer is faulty.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
