1994 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Code 22 (PRIZM) - Engine Coolant Temperature Sensor, Open Or Shorted Circuit: Notes

Engine Coolant Temperature (ECT) sensor is a thermistor in series with a fixed resistor in ECM. ECM applies 5 volts to sensor. ECM monitors voltage across ECT sensor and converts it into a temperature reading. When engine is cold, ECT sensor resistance is high. When engine is warm, ECT sensor resistance is low. Therefore, when engine is cold, ECM receives a high voltage input and when engine is warm, ECM receives a low voltage input. Code 22 will set if voltage input at ECM indicates either a very low or very high engine coolant temperature for at least .5 second.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Checks for open or short to ground in White wire between ECM and ECT sensor or a faulty ECM.
  2. Checks for open in Brown wire between ECM and ECT sensor or a faulty ECM.
  3. Determines if problem is a faulty ECT sensor or ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.