1994 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Chart A1-5, Fuel Injector Circuit Check (Engine No-Start): Notes

When ignition switch is turned to ON or START position (engine running), ECM will energize/de-energize fuel injector solenoid coil. With coil energized, a plunger is activated, allowing pressurized fuel to be sprayed through fuel injectors into combustion chamber where it is mixed with air from intake manifold, thus creating proper air/fuel mixture needed for combustion.

NOTE: Test numbers refer to numbers on diagnostic chart.
  1. Checks if ECM is controlling ground path to fuel injectors.
  2. Checks resistance of fuel injectors.
  3. Checks for open or short to ground in Black or Black/Red wire between fuel injectors and ECM, or for faulty fuel injectors or ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.