Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Valve Clearance
CAUTION:
Valve clearance should be checked with engine cold.
VALVE CLEARANCE SPECIFICATIONS
| Application | In. (mm) | ||
|---|---|---|---|
| Exhaust | (1) .010-.014 (.25-.35) | ||
| Intake | (1) .006-.010 (.15-.25) | ||
|
|||
- Disconnect negative battery cable. Remove valve cover and gaskets. Rotate crankshaft until No. 1 cylinder is at TDC of compression stroke. Ensure timing mark on crankshaft pulley aligns with zero mark on timing belt cover.
- Valves on No. 1 cylinder should have clearance and be closed. If both valves on No. 1 cylinder are not closed, rotate crankshaft one revolution (360 degrees).
- Using feeler gauge, measure and record clearance between camshaft lobe and adjuster shim on intake valves of cylinders No. 1 and 2, and exhaust valves of cylinders No. 1 and 3. Adjust valve clearance if not within specification. See VALVE CLEARANCE SPECIFICATIONS table.
- Rotate crankshaft one revolution (360 degrees). Check clearance on intake valves of cylinders No. 3 and 4, and exhaust valves of cylinders No. 2 and 4. Adjust valve clearance if not within specification. See VALVE CLEARANCE SPECIFICATIONS table.
- To adjust valve clearance, rotate crankshaft until camshaft lobe is pointing upward, away from adjuster shim. Install Spring Compressor (J-39871-1) between camshaft and adjuster shim to push lifter downward. See Fig 1.
- Insert Lifter Detainer (J-39871-2) between camshaft and lifter. Ensure bottom edge of lifter detainer is positioned on lifter, not on adjuster shim. See Fig 1. This will hold lifter away from camshaft.
- Remove spring compressor. Using small screwdriver and magnet, remove adjuster shim. Replacement adjuster shim thickness can be determined by using adjuster shim charts. See Fig 2 and Fig 3
. Adjuster shim thickness can also be determined by using following formula: N = T + A
- N = Thickness of adjuster shim required.
- T = Thickness of adjuster shim removed.
- A = Measured clearance minus valve clearance specification.
- To install NEW adjuster shim, depress valve spring using spring compressor. Install adjuster shim. Remove lifter detainer and spring compressor.
- Ensure valve clearance is within specification. To install remaining components, reverse removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
