Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Geo Metro XFiFACTORY OEM SERVICE PROCEDURE
Trouble Code Definitions
NOTE:
Trouble codes will be recorded at various operating times. Some codes require sensor or switch operation for 5 seconds and others may require longer under certain conditions. Some codes may not set in a service bay operational mode.
TROUBLE CODE IDENTIFICATION
| Code | Circuit Affected | Probable Cause | ||
|---|---|---|---|---|
| 13 | Oxygen Sensor | Signal Voltage Does Not Change | ||
| 14 | Coolant Temp. Sensor | Low Temp. Indicated | ||
| 15 | Coolant Temp. Sensor | High Temp. Indicated | ||
| 21 | Throttle Position Sensor | Signal Voltage High | ||
| 22 | Throttle Position Sensor | Signal Voltage Low | ||
| 23 | Intake Air Temp. Sensor | Low Temp. Indicated | ||
| 24 | Vehicle Speed Sensor | No Speedometer | ||
| 25 | Intake Air Temp. Sensor | High Temp. Indicated | ||
| 31 | MAP Sensor | Low Voltage Input, Low Vacuum | ||
| 32 | MAP Sensor | High Voltage Input, High Vacuum | ||
| 41 | Ignition Signal | No Signal | ||
| 42 | Camshaft Position Sensor | No Signal For 2 Seconds | ||
| 46 (1) | Idle Speed Control Motor | ISC Motor Inoperative | ||
| 51 | EGR System | EGR SV Valve Inoperative | ||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.