Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Geo Metro L3-61 1.0LFACTORY OEM SERVICE PROCEDURE
System Specifications
Fuel Filter Mounting Bolts 15 Nm (11 lb-ft)
Fuel Tank Mounting Bolts 25 Nm (18 lb-ft)
Fuel Pressure Regulator 2.0 Nm (18 lb-in)
Idle Air Control Valve (IAC) 3.0 Nm (27 lb-in)
Throttle Body Attach Bolts 23 Nm (17 lb-ft)
Throttle Position Sensor Attach Screws 2.0 Nm (18 lb-in)
Fuel Tank Mounting Bolts 25 Nm (18 lb-ft)
Fuel Pressure Regulator 2.0 Nm (18 lb-in)
Idle Air Control Valve (IAC) 3.0 Nm (27 lb-in)
Throttle Body Attach Bolts 23 Nm (17 lb-ft)
Throttle Position Sensor Attach Screws 2.0 Nm (18 lb-in)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.