Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Geo Tracker LSi, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||||
|---|---|---|---|---|---|
| Clutch Cable Adjustment Nuts "A" & "B" | 13 (18) | ||||
| Clutch Cable Grommet Bolts | (1) | ||||
| Clutch Pedal Shaft Nut & Bolt | 18 (24) | ||||
| Clutch Start Switch Lock Nut | (2) | ||||
| Flywheel Bolts | 48 (65) | ||||
| Pressure Plate | 17 (23) | ||||
| Transmission-To-Crossmember Bolts | 63 (85) | ||||
| Transmission-To-Engine Bolts | 63 (85) | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.