1993 Geo Tracker LSi, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor

Disconnect TP sensor electrical connection. Install proper thickness feeler gauge between stop screw and lever. Using ohmmeter, check continuity or resistance between designated terminals. Adjust or replace TP sensor if it is not within specification. See THROTTLE POSITION (TP) SENSOR RESISTANCEΒ  . See Fig 1 for terminal identification.

Fig 1: Throttle Position Sensor Terminal ID
G121710Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.