Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Geo Storm Base, AutomaticFACTORY OEM SERVICE PROCEDURE
EFI Main Relay
- EFI main relay is located in fuse/relay block on left side of engine compartment, near battery. Remove EFI main relay from fuse/relay block.
- Using ohmmeter, ensure continuity exists between Black and Black/Yellow wire terminals of EFI main relay. Apply battery voltage to Black/Yellow wire terminal, and ground Black wire terminal. Continuity should exist between Red/White and Red/Green wire terminals of relay. Replace EFI main relay if continuity is not as specified.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.