1993 Geo Storm Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Diode
SOHC (VIN 6) In relay block, near right front strut tower. See Figure .
DOHC (VIN 8) In relay block, near right front strut tower. See Figure .
A/C-Heater Blower Motor Resistor At bottom of A/C-heater blower motor housing. See Figure .
Daytime Running Light (DRL) Resistor In front of engine compartment, behind center of grille.
Check/Test Connectors
A/T Behind right kick panel.
Cooling Fan On left rear of engine compartment, near firewall.
DERM Behind right kick panel.
Data Link Connector (DLC)
Component Location Behind right kick panel. See Figure .
SOHC (VIN 6) Behind right kick panel. See Figure .
DOHC (VIN 8) Behind right kick panel. See Figure .
Rear Defogger Condenser Behind left rear passenger compartment trim panel.
SIR Resistor Behind left side of dash, above steering column.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.