Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Ignition Timing Retard (Prizm LSi)
On Prizm LSi, a knock sensor, located in rear of cylinder block, sends a variable AC voltage signal to ECM depending on engine detonation. ECM uses this signal to determine if ignition timing should be retarded. Testing information is not supplied by manufacturer. If a fault occurs in retard circuit, a Code 52 will set in ECM memory. If a code is set, see TESTS W/CODES article in this section.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.