1992 Geo Tracker LSi, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor

Disconnect TPS electrical connection. Install proper thickness feeler gauge between stop screw and lever. Using ohmmeter, check continuity or resistance between designated terminals. Adjust or replace TPS if not within specification. See THROTTLE POSITION SENSOR (TPS) RESISTANCE  .

NOTE: See Fig 1 for terminal identification.
THROTTLE POSITION SENSOR (TPS) RESISTANCE

Application Condition Ohms
Between Terminals C & D (1) 0-500
Between Terminals C & D (2) No Continuity
Between Terminals A & D 3500-6500
Between Terminals B & D
At Idle (3) 300-2000
At Wide Open Throttle 2000-6500
(1) With .012" (.30 mm) feeler gauge installed between stop screw and lever.
(2) With .022" (.56 mm) feeler gauge installed between stop screw and lever.
(3) To position throttle valve at idle, apply approximately 18 in. Hg vacuum to throttle opener valve.
Fig 1: Throttle Position Sensor Terminal ID
G121710Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.